Bespoke application specific training courses have been designed and developed to meet a wide variety of customer needs. Smaller customers who lack their own internal training regimes can take advantage of Forth’s extensive experience of both conventional and specialist NDT techniques relating to numerous energy sectors.
Training courses can range from a 1 day refresher through to more extensive specialist NDT validation packages.
Forth inspection Solutions offer specific training in the detection of flange face corrosion using Phased array ultrasonic testing.
Forth trains technicians to use the calibration samples to develop familiarity with the typical responses from the various targets introduced. The geometry signals must be understood and accounted for so that technicians can quickly confirm quality data has been obtained.
Ensuring the data quality is acceptable is critical for production scanning; in some cases the analysis of the collected data can be performed by other technicians based in on-site office areas, or even remotely performed from another country.
Development of analysis methodology and display options will enable rapid evaluation of the flange face data. Collecting the entire A-scan data set allows post analysis and will enable comparison of previous inspection campaigns.
Forth inspection Solutions offer specific training in phased array bolt inspection.
Forth trains technicians to use the various calibration samples to develop familiarity with the typical responses from the various targets introduced. The geometry signals must be understood and accounted for so that technicians can quickly confirm quality data has been obtained.
Ensuring the data quality is acceptable is critical for production scanning; in some cases the analysis of the collected data can be performed by other technicians based in on-site office areas, or even remotely performed from another country.
Development of analysis methodology and display options will enable rapid evaluation of the bolt PAUT data. Collecting the entire A-scan data set allows post analysis and will enable comparison of previous inspection campaigns.
Forth inspection Solutions offer specific training in CRA inspection using ultrasonic techniques.
Manual ultrasonics training is conducted using a combination of angle compression and creep wave probes, whilst phased array ultrasonic testing primarily uses dual matrix array probes.
The training covers various CRA material, inclusive of clad pipe, austenitic and Duplex weldments for the detection and evaluation of new fabrication defects.
Candidates are also instructed in the process of ultrasonic testability trials in accordance with BS EN ISO 22825.
